Zetta Audio S-10 700
10″ subwoofer · 4 Ω · 700 W RMS
The Zetta Audio S-10 700 is a 10″ subwoofer. With Qts 0.41 and EBP 79 it works both sealed and ported: sealed is tighter and smaller, ported is deeper and louder.
| Source | zettaaudio.com.br · manufacturer data |
|---|---|
| Checked against source | October 2026 |
| Thiele/Small parameters | complete |
| Mounting dimensions | 3 of 4 — missing: magnet diameter; the designer will use an estimate |
Recommended box
For a sedan, one sub, 700 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.
Sealed
smaller, tighter| Bass character (Qtc) | Flat and accurate · 0.65 |
|---|---|
| Fc | 54 Hz |
| F3 (−3 dB, no cabin gain) | 62 Hz |
| Example box (outside) | 12 5/8″ × 12 5/8″ × 8 5/8″ |
Ported
deeper, louder| Tuning (Fb) | 45 Hz |
|---|---|
| Port | 2 round ports Ø2 1/2″, 15 1/8″ long |
| Port velocity at 700 W | 152 ft/s |
| F3 (−3 dB, no cabin gain) | 40 Hz |
| Example box (outside) | 18 7/8″ × 15 3/4″ × 8 1/16″ |
At 700 W this example’s port will be noisy: air speed 152 ft/s, while the limit is 82 ft/s. It stays quiet up to about 200 W. Full power needs a port of at least 18.5 in², which means a bigger box than this example — size it in the designer.
Open ported box in designerDeeper: 0.92 ft³ (26 L) tuned to 37 Hz, 21 15/16″ × 15 3/4″ × 8 1/16″ outside — a bigger box with flatter deep bass. Open in the calculator
Projects with this subwoofer
Boxes that users designed and published: plans, cut sheet and response graph.
Thiele/Small parameters
| Size | 10″ |
|---|---|
| Voice coils | 4 Ω |
| RMS power | 700 W |
| Fs | 34 Hz |
| Qts | 0.41 |
| Qes | 0.428 |
| Qms | 8.86 |
| Vas | 0.69 ft³ |
| Re | 3.6 Ω |
|---|---|
| Sd | 48.7 in² |
| Xmax | 0.46″ |
| Vd | 22.6 in³ calc. |
| Mms | 157 g calc. |
| BL | 16.8 T·m calc. |
| EBP | 79 — sealed or ported calc. |
| Sensitivity, 1 W / 1 m | 84.5 dB calc. |
Mounting dimensions
| Cutout diameter | 9 1/4″ |
|---|---|
| Mounting depth | 5 1/2″ |
| Overall diameter | 10 1/4″ |
Where it fits in a vehicle
Spots from our vehicle guides where the cutout, mounting depth and recommended box fit. The spot sizes are approximate — measure your own vehicle.
- F-150 SuperCrew — under the rear seat sealed and ported box
- Ram Crew Cab — under the rear seat sealed and ported box
- Tacoma Double Cab — under the rear seat sealed and ported box
- Tacoma Access Cab — behind the front seats sealed and ported box
- Bronco 4-door — behind the rear seat sealed and ported box
- Wrangler 4-door, hard top — behind the rear seat sealed and ported box
- Wrangler 4-door, soft top — behind the rear seat sealed and ported box
- Silverado / Sierra Crew Cab — under the rear seat sealed and ported box
- Spare tire well sealed box
- Polaris RZR / Ranger — under the seat sealed box
- Can-Am — under the seat sealed box
- FJ Cruiser — behind the rear seat sealed and ported box
- El Camino 1978–87 — behind the seat sealed and ported box
- Cherokee XJ — cargo area, spare moved out sealed and ported box
- Excursion — behind the third row sealed and ported box
- Mustang 2015–2023 coupe — trunk sealed and ported box
- Challenger / Charger — trunk sealed and ported box
- Tesla Model 3 — well under the trunk floor sealed and ported box
- Club Car Precedent — under the rear seat sealed and ported box
“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.
Data sources
Other Zetta Audio 10″ models
- Zetta Audio L-10 300 10″ · 4 Ω
- Zetta Audio M-10 450 10″ · 4 Ω
- Zetta Audio V-10 900 (4+4 Ohm) 10″ · dual 4 Ω
- Zetta Audio V-10 EVO 1100 10″ · dual 4 Ω
Similar 10″ subwoofers from other brands
Close in Fs, Qts and Vas — a box of similar volume will suit them.
- Dayton Audio SS10-22 0.53 ft³ sealed · 0.85 ft³ ported
- Sundown Audio Ev4-10 D4 0.46 ft³ sealed · 1.02 ft³ ported
- Elemental Designs E10a 0.46 ft³ sealed · 0.81 ft³ ported
- Ground Zero GZHW 10-D2 FLAT (2x2 Ohm) 0.53 ft³ sealed · 0.88 ft³ ported
- Ground Zero GZHW 10SPL-D2 FLAT (2x2 Ohm) 0.49 ft³ sealed · 0.88 ft³ ported
- Infinity Kappa 100.9W 0.46 ft³ sealed · 0.81 ft³ ported
All 10″ subwoofers in our database →
FAQ
What box does the Zetta Audio S-10 700 need?
Recommended net volume: 0.46 ft³ sealed, 0.78 ft³ ported tuned to 45 Hz — for one sub in a sedan at 700 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.
What are the Zetta Audio S-10 700 Thiele/Small specs?
Fs 34 Hz, Qts 0.41, Vas 0.69 ft³, Xmax 0.46″, Sd 48.7 in².
What is the Zetta Audio S-10 700 mounting depth?
Mounting depth is 5 1/2″, cutout diameter 9 1/4″. The inside depth of the box must exceed the mounting depth by at least 1″.
How much power does the Zetta Audio S-10 700 handle and how do I wire it?
RMS power rating: 700 W. Wiring for several subs and amp power — in the wiring calculator.
Is the Zetta Audio S-10 700 better sealed or ported?
EBP 79: both work — sealed 0.46 ft³ is tighter and smaller, ported 0.78 ft³ tuned to 45 Hz is deeper and louder.
What port does the Zetta Audio S-10 700 need?
For the 0.78 ft³ ported box tuned to 45 Hz: 2 round ports Ø2 1/2″, 15 1/8″ long, area 10 in²; or a round port Ø3 9/16″, ≈ 14 5/16″ long. Port air speed at 700 W: 152 ft/s.
What box do two Zetta Audio S-10 700 subs need?
Two subs need twice the volume: 0.92 ft³ sealed, or 1.55 ft³ ported at the same 45 Hz tuning with twice the port area. One shared chamber or one per sub — whatever fits your vehicle.