Swat REV-10
10″ subwoofer · dual 2 Ω · 450 W RMS
Fs 38.2 HzQts 0.50Vas 0.64 ft³Xmax 0.63″
Recommended box
For a sedan, one sub, 450 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.
Sealed
| Net volume | 0.46 ft³ (13 L) |
|---|---|
| Qtc | 0.77 |
| Fc | 59 Hz |
| F3 (−3 dB, no cabin gain) | 57 Hz |
| Example box (outside) | 12 5/8″ × 12 5/8″ × 8 5/8″ |
Ported
| Net volume | 1.31 ft³ (37 L) |
|---|---|
| Tuning (Fb) | 33 Hz |
| Port | slot 1 9/16 × 14 5/16″, 38 1/2″ long |
| Port velocity at 450 W | 60 ft/s |
| F3 (−3 dB, no cabin gain) | 30 Hz |
| Example box (outside) | 31 1/2″ × 15 3/4″ × 9 11/16″ |
Thiele/Small parameters
| Fs | 38.2 Hz |
|---|---|
| Qts | 0.50 |
| Qes | 0.546 |
| Qms | 5.92 |
| Vas | 0.64 ft³ |
| Re (one coil) | 1.65 Ω |
| Sd | 52.2 in² |
| Xmax | 0.63″ |
| Vd | 32.9 in³ calc. |
| Mms | 155 g calc. |
| BL | 10.6 T·m calc. |
| EBP | 70 — sealed or ported calc. |
| Sensitivity, 1 W / 1 m | 84.6 dB calc. |
General
| Size | 10″ |
|---|---|
| Voice coils | dual 2 Ω |
| RMS power | 450 W |
Mounting dimensions
| Cutout diameter | 9 5/16″ |
|---|---|
| Mounting depth | 5 3/16″ |
Qes and Qms are not on the spec sheet — calculated from Qts, motor strength BL and Re.
Judging by its value, the published Re is for both coils in series — converted to per coil.
“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.
Data sources
Other Swat 10″ models
- Swat MAS-10 10″ · 4 Ω
- Swat MAS-10 v.2 10″ · 4 Ω
- Swat REV-10 v.2 10″ · dual 2 Ω
- Swat SW M10 10″ · 4 Ω