DD Audio 9510L ESP D2

10″ subwoofer · dual 2 Ω · 2,500 W RMS

Fs 34.3 HzQts 0.37Vas 0.72 ft³Xmax 1.26″

Recommended box

For a sedan, one sub, 2,500 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

Net volume0.76 ft³ (21.5 L)
Qtc0.51
Fc48 Hz
F3 (−3 dB, no cabin gain)73 Hz
Example box (outside)13 3/8″ × 13 3/8″ × 11 5/16″
Open sealed box in designer

Ported

Net volume1.02 ft³ (29 L)
Tuning (Fb)32 Hz
Portslot 1 15/16 × 14 5/16″, 67 1/2″ long
Port velocity at 2,500 W96 ft/s
F3 (−3 dB, no cabin gain)31 Hz
Example box (outside)31 1/2″ × 15 3/4″ × 11 1/8″

The volume and tuning are the recommendation, but the port doesn’t fit this example box. Size the box and port in the designer.

Open ported box in designer
2030405060801001502006066727884HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Fs34.3 Hz
Qts0.37
Qes0.398
Qms5.09
Vas0.72 ft³
Re (one coil)≈ 1.7 Ω
Sd≈ 52.7 in²
Xmax1.26″
EBP86 — sealed or ported calc.
Sensitivity, 1 W / 1 m85.1 dB calc.

General

Size10″
Voice coilsdual 2 Ω
RMS power2,500 W

Mounting dimensions

Ø11 7/16″cutout Ø10 3/16″mounting depth 8 13/16″magnet Ø9 5/16″
Cutout diameter10 3/16″
Mounting depth8 13/16″
Overall diameter11 7/16″
Magnet diameter9 5/16″

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other DD Audio 10″ models