Audiobahn AW1006T

10″ subwoofer · dual 4 Ω · 900 W RMS

35.2 HzFs, resonance
0.73Qts
0.42 ft³Vas
0.75″Xmax
900 WRMS

The Audiobahn AW1006T is a 10″ subwoofer. With Qts 0.73 and EBP 40 it suits a sealed box: tight bass in a small enclosure; a ported box would need a lot of volume. Long excursion (Xmax 0.75″) — built for loud music and high power.

Sourceweb.archive.org · manufacturer data
Checked against sourceOctober 2026
Thiele/Small parameterscomplete
Mounting dimensions3 of 4 — missing: magnet diameter; the designer will use an estimate

Recommended box

For a sedan, one sub, 900 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

smaller, tighter
0.85 ft³ (24 L)
Net volume
Bass character (Qtc)Tight and punchy · 0.89
Fc43 Hz
F3 (−3 dB, no cabin gain)37 Hz
Example box (outside)12 3/16″ × 12 3/16″ × 14 15/16″
Open sealed box in designer

Ported

deeper, louder
0.78 ft³ (22 L)
Net volume
Tuning (Fb)47 Hz
Port2 round ports Ø2 1/2″, 13 11/16″ long
Port velocity at 900 W162 ft/s
F3 (−3 dB, no cabin gain)38 Hz
Example box (outside)16 7/8″ × 15 3/4″ × 8 11/16″

At 900 W this example’s port will be noisy: air speed 162 ft/s, while the limit is 82 ft/s. It stays quiet up to about 230 W. Full power needs a port of at least 19.7 in², which means a bigger box than this example — size it in the designer.

Open ported box in designer

Deeper: 1.87 ft³ (53 L) tuned to 25 Hz, 31 1/2″ × 15 3/4″ × 12 5/8″ outside — a bigger box with flatter deep bass. Open in the calculator

Where to buy Amazon
203040506080100150200606672788490HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Size10″
Voice coilsdual 4 Ω
RMS power900 W
Fs35.2 Hz
Qts0.73
Qes0.89
Qms3.93
Vas0.42 ft³
Re (one coil)3 Ω
Sd48.1 in²
Xmax0.75″
Vd35.9 in³ calc.
Mms232 g calc.
BL13.1 T·m calc.
EBP40 — suits sealed calc.
Sensitivity, 1 W / 1 m79.7 dB calc.

Mounting dimensions

Ø10 1/4″cutout Ø9″mounting depth 6 1/4″magnet Ø≈ 5 7/8″
Cutout diameter9″
Mounting depth6 1/4″
Overall diameter10 1/4″

Where it fits in a vehicle

Spots from our vehicle guides where the cutout, mounting depth and recommended box fit. The spot sizes are approximate — measure your own vehicle.

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other Audiobahn 10″ models

Similar 10″ subwoofers from other brands

Close in Fs, Qts and Vas — a box of similar volume will suit them.

FAQ

What box does the Audiobahn AW1006T need?

Recommended net volume: 0.85 ft³ sealed, 0.78 ft³ ported tuned to 47 Hz — for one sub in a sedan at 900 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.

What are the Audiobahn AW1006T Thiele/Small specs?

Fs 35.2 Hz, Qts 0.73, Vas 0.42 ft³, Xmax 0.75″, Sd 48.1 in².

What is the Audiobahn AW1006T mounting depth?

Mounting depth is 6 1/4″, cutout diameter 9″. The inside depth of the box must exceed the mounting depth by at least 1″.

How much power does the Audiobahn AW1006T handle and how do I wire it?

RMS power rating: 900 W. Dual 4 Ω voice coils: series gives 8 Ω, parallel gives 2 Ω at the amp. Wiring for several subs and amp power — in the wiring calculator.

Is the Audiobahn AW1006T better sealed or ported?

EBP 40: a sealed box (0.85 ft³) suits it best — tight bass in a compact enclosure. Ported is possible (0.78 ft³, tuned to 47 Hz) but larger.

What port does the Audiobahn AW1006T need?

For the 0.78 ft³ ported box tuned to 47 Hz: 2 round ports Ø2 1/2″, 13 11/16″ long, area 10 in²; or a round port Ø3 9/16″, ≈ 12 15/16″ long. Port air speed at 900 W: 162 ft/s.

What box do two Audiobahn AW1006T subs need?

Two subs need twice the volume: 1.70 ft³ sealed, or 1.55 ft³ ported at the same 47 Hz tuning with twice the port area. One shared chamber or one per sub — whatever fits your vehicle.