Audiobahn AWIS10P

10″ subwoofer · 2 Ω · 1,500 W RMS

58 HzFs, resonance
0.48Qts
0.26 ft³Vas
0.49″Xmax
1,500 WRMS

The Audiobahn AWIS10P is a 10″ subwoofer. With Qts 0.48 and EBP 114 it suits a ported box: deeper and louder; sealed, the bass sounds a bit dry.

Sourceweb.archive.org · manufacturer data
Checked against sourceOctober 2026
Thiele/Small parameterscomplete
Mounting dimensions2 of 4 — missing: frame outer diameter, magnet diameter; the designer will use an estimate
The published specs don’t add up:

Recommended box

For a sedan, one sub, 1,500 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

smaller, tighter
0.57 ft³ (16 L)
Net volume
Bass character (Qtc)Dry and tight · 0.58
Fc70 Hz
F3 (−3 dB, no cabin gain)91 Hz
Example box (outside)12 3/16″ × 12 3/16″ × 10 3/4″
Open sealed box in designer

Ported

deeper, louder
0.78 ft³ (22 L)
Net volume
Tuning (Fb)38 Hz
Portslot 1 15/16 × 14 5/16″, 62 13/16″ long
Port velocity at 1,500 W77 ft/s
F3 (−3 dB, no cabin gain)36 Hz
Example box (outside)31 1/2″ × 15 3/4″ × 9 3/4″

The volume and tuning are the recommendation, but the port doesn’t fit this example box. Size the box and port in the designer.

Open ported box in designer

Deeper: 0.95 ft³ (27 L) tuned to 40 Hz, 15 1/2″ × 15 3/4″ × 15 9/16″ outside — a bigger box with flatter deep bass. Open in the calculator

Where to buy Amazon
203040506080100150200606672788490HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Size10″
Voice coils2 Ω
RMS power1,500 W
Fs58 Hz
Qts0.48
Qes0.51
Qms7.59
Vas0.26 ft³
Re1.3 Ω
Sd49.6 in²
Xmax0.49″
Vd24.4 in³ calc.
Mms146 g calc.
BL11.6 T·m calc.
EBP114 — suits ported calc.
Sensitivity, 1 W / 1 m86.6 dB calc.

Mounting dimensions

Ø≈ 10 1/16″cutout Ø8 7/8″mounting depth 8 1/4″magnet Ø≈ 5 3/4″
Cutout diameter8 7/8″
Mounting depth8 1/4″

Where it fits in a vehicle

Spots from our vehicle guides where the cutout, mounting depth and recommended box fit. The spot sizes are approximate — measure your own vehicle.

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other Audiobahn 10″ models

Similar 10″ subwoofers from other brands

Close in Fs, Qts and Vas — a box of similar volume will suit them.

FAQ

What box does the Audiobahn AWIS10P need?

Recommended net volume: 0.57 ft³ sealed, 0.78 ft³ ported tuned to 38 Hz — for one sub in a sedan at 1,500 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.

What are the Audiobahn AWIS10P Thiele/Small specs?

Fs 58 Hz, Qts 0.48, Vas 0.26 ft³, Xmax 0.49″, Sd 49.6 in².

What is the Audiobahn AWIS10P mounting depth?

Mounting depth is 8 1/4″, cutout diameter 8 7/8″. The inside depth of the box must exceed the mounting depth by at least 1″.

How much power does the Audiobahn AWIS10P handle and how do I wire it?

RMS power rating: 1,500 W. Wiring for several subs and amp power — in the wiring calculator.

Is the Audiobahn AWIS10P better sealed or ported?

EBP 114: a ported box (0.78 ft³, tuned to 38 Hz) suits it best — deeper and louder. Sealed (0.57 ft³) the bass is drier.

What port does the Audiobahn AWIS10P need?

For the 0.78 ft³ ported box tuned to 38 Hz: slot 1 15/16 × 14 5/16″, 62 13/16″ long, area 28.2 in²; or a round port Ø6″, ≈ 62 13/16″ long. Port air speed at 1,500 W: 77 ft/s.

What box do two Audiobahn AWIS10P subs need?

Two subs need twice the volume: 1.13 ft³ sealed, or 1.55 ft³ ported at the same 38 Hz tuning with twice the port area. One shared chamber or one per sub — whatever fits your vehicle.