Audiobahn AWES10P

10″ subwoofer · DVC · 900 W RMS

30 HzFs, resonance
0.50Qts
0.71 ft³Vas
0.51″Xmax
900 WRMS

The Audiobahn AWES10P is a 10″ subwoofer. With Qts 0.50 and EBP 56 it works both sealed and ported: sealed is tighter and smaller, ported is deeper and louder.

Sourceweb.archive.org · manufacturer data
Checked against sourceOctober 2026
Thiele/Small parameterscomplete
Mounting dimensions2 of 4 — missing: frame outer diameter, magnet diameter; the designer will use an estimate

Recommended box

For a sedan, one sub, 900 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

smaller, tighter
0.57 ft³ (16 L)
Net volume
Bass character (Qtc)Flat and accurate · 0.75
Fc45 Hz
F3 (−3 dB, no cabin gain)45 Hz
Example box (outside)12 3/16″ × 12 3/16″ × 10 3/4″
Open sealed box in designer

Ported

deeper, louder
0.71 ft³ (20 L)
Net volume
Tuning (Fb)33 Hz
Portslot 1 15/16 × 14 5/16″, 93 5/8″ long
Port velocity at 900 W44 ft/s
F3 (−3 dB, no cabin gain)31 Hz
Example box (outside)31 1/2″ × 15 3/4″ × 11 9/16″

The volume and tuning are the recommendation, but the port doesn’t fit this example box. Size the box and port in the designer.

Open ported box in designer

Deeper: 1.48 ft³ (42 L) tuned to 30 Hz, 23 1/16″ × 15 3/4″ × 10 13/16″ outside — a bigger box with flatter deep bass. Open in the calculator

Where to buy Amazon
2030405060801001502006066727884HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Size10″
Voice coilsDVC
RMS power900 W
Fs30 Hz
Qts0.50
Qes0.54
Qms6.99
Vas0.71 ft³
Re (one coil)3.6 Ω
Sd45 in²
Xmax0.51″
Vd23 in³ calc.
Mms166 g calc.
BL14.4 T·m calc.
EBP56 — sealed or ported calc.
Sensitivity, 1 W / 1 m82 dB calc.

Mounting dimensions

Ø≈ 10 1/16″cutout Ø8 7/8″mounting depth 8 1/4″magnet Ø≈ 5 3/4″
Cutout diameter8 7/8″
Mounting depth8 1/4″

Where it fits in a vehicle

Spots from our vehicle guides where the cutout, mounting depth and recommended box fit. The spot sizes are approximate — measure your own vehicle.

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other Audiobahn 10″ models

Similar 10″ subwoofers from other brands

Close in Fs, Qts and Vas — a box of similar volume will suit them.

FAQ

What box does the Audiobahn AWES10P need?

Recommended net volume: 0.57 ft³ sealed, 0.71 ft³ ported tuned to 33 Hz — for one sub in a sedan at 900 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.

What are the Audiobahn AWES10P Thiele/Small specs?

Fs 30 Hz, Qts 0.50, Vas 0.71 ft³, Xmax 0.51″, Sd 45 in².

What is the Audiobahn AWES10P mounting depth?

Mounting depth is 8 1/4″, cutout diameter 8 7/8″. The inside depth of the box must exceed the mounting depth by at least 1″.

How much power does the Audiobahn AWES10P handle and how do I wire it?

RMS power rating: 900 W. Wiring for several subs and amp power — in the wiring calculator.

Is the Audiobahn AWES10P better sealed or ported?

EBP 56: both work — sealed 0.57 ft³ is tighter and smaller, ported 0.71 ft³ tuned to 33 Hz is deeper and louder.

What port does the Audiobahn AWES10P need?

For the 0.71 ft³ ported box tuned to 33 Hz: slot 1 15/16 × 14 5/16″, 93 5/8″ long, area 28.2 in²; or a round port Ø6″, ≈ 93 5/8″ long. Port air speed at 900 W: 44 ft/s.

What box do two Audiobahn AWES10P subs need?

Two subs need twice the volume: 1.13 ft³ sealed, or 1.41 ft³ ported at the same 33 Hz tuning with twice the port area. One shared chamber or one per sub — whatever fits your vehicle.