Audiopipe TXX-BD4-15

15″ subwoofer · dual 4 Ω · 1,400 W RMS

30 HzFs, resonance
0.37Qts
2.44 ft³Vas
0.33″Xmax
1,400 WRMS

The Audiopipe TXX-BD4-15 is a 15″ subwoofer. With Qts 0.37 and EBP 68 it works both sealed and ported: sealed is tighter and smaller, ported is deeper and louder. Modest excursion (Xmax 0.33″) — for clean sound at moderate levels, not for SPL competitions.

Sourceweb.archive.org · manufacturer data
Checked against sourceOctober 2026
Thiele/Small parameterscomplete
Mounting dimensions3 of 4 — missing: magnet diameter; the designer will use an estimate

Recommended box

For a sedan, one sub, 1,400 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

smaller, tighter
1.20 ft³ (34 L)
Net volume
Bass character (Qtc)Flat and accurate · 0.64
Fc52 Hz
F3 (−3 dB, no cabin gain)61 Hz
Example box (outside)16 15/16″ × 16 15/16″ × 11 5/16″
Open sealed box in designer

Ported

deeper, louder
3.92 ft³ (111 L)
Net volume
Tuning (Fb)33 Hz
Portslot 3 15/16 × 16 5/16″, 33 9/16″ long
Port velocity at 1,400 W64 ft/s
F3 (−3 dB, no cabin gain)30 Hz
Example box (outside)31 1/2″ × 17 11/16″ × 20 13/16″
Open ported box in designer

Deeper: 2.51 ft³ (71 L) tuned to 32 Hz, 31 1/2″ × 17 11/16″ × 15 3/8″ outside — a bigger box with flatter deep bass. Open in the calculator

Where to buy Amazon
203040506080100150200667278849096HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Size15″
Voice coilsdual 4 Ω
RMS power1,400 W
Fs30 Hz
Qts0.37
Qes0.44
Qms2.3
Vas2.44 ft³
Re (one coil)3.6 Ω
Sd131.8 in²
Xmax0.33″
Vd44.1 in³ calc.
Mms417 g calc.
BL25.4 T·m calc.
EBP68 — sealed or ported calc.
Sensitivity, 1 W / 1 m88.3 dB calc.

Mounting dimensions

Ø15 1/2″cutout Ø13 13/16″mounting depth 8 7/8″magnet Ø≈ 9″
Cutout diameter13 13/16″
Mounting depth8 7/8″
Overall diameter15 1/2″

Where it fits in a vehicle

Spots from our vehicle guides where the cutout, mounting depth and recommended box fit. The spot sizes are approximate — measure your own vehicle.

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other Audiopipe 15″ models

Similar 15″ subwoofers from other brands

Close in Fs, Qts and Vas — a box of similar volume will suit them.

FAQ

What box does the Audiopipe TXX-BD4-15 need?

Recommended net volume: 1.20 ft³ sealed, 3.92 ft³ ported tuned to 33 Hz — for one sub in a sedan at 1,400 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.

What are the Audiopipe TXX-BD4-15 Thiele/Small specs?

Fs 30 Hz, Qts 0.37, Vas 2.44 ft³, Xmax 0.33″, Sd 131.8 in².

What is the Audiopipe TXX-BD4-15 mounting depth?

Mounting depth is 8 7/8″, cutout diameter 13 13/16″. The inside depth of the box must exceed the mounting depth by at least 1″.

How much power does the Audiopipe TXX-BD4-15 handle and how do I wire it?

RMS power rating: 1,400 W. Dual 4 Ω voice coils: series gives 8 Ω, parallel gives 2 Ω at the amp. Wiring for several subs and amp power — in the wiring calculator.

Is the Audiopipe TXX-BD4-15 better sealed or ported?

EBP 68: both work — sealed 1.20 ft³ is tighter and smaller, ported 3.92 ft³ tuned to 33 Hz is deeper and louder.

What port does the Audiopipe TXX-BD4-15 need?

For the 3.92 ft³ ported box tuned to 33 Hz: slot 3 15/16 × 16 5/16″, 33 9/16″ long, area 64.2 in²; or a round port Ø9 1/16″, ≈ 33 9/16″ long. Port air speed at 1,400 W: 64 ft/s.

What box do two Audiopipe TXX-BD4-15 subs need?

Two subs need twice the volume: 2.40 ft³ sealed, or 7.84 ft³ ported at the same 33 Hz tuning with twice the port area. One shared chamber or one per sub — whatever fits your vehicle.