Sky High Car Audio FMX-12 D1

12″ subwoofer · dual 1 Ω · 3,500 W RMS

29.6 HzFs, resonance
0.47Qts
0.94 ft³Vas
1.46″Xmax
3,500 WRMS
Sourceskyhighcaraudio.com · manufacturer data
Checked against sourceOctober 2026
Thiele/Small parameterscomplete
Mounting dimensions3 of 4 — missing: magnet diameter; the designer will use an estimate

Recommended box

For a sedan, one sub, 3,500 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.

Sealed

smaller, tighter
0.92 ft³ (26 L)
Net volume
Bass character (Qtc)Flat and accurate · 0.67
Fc42 Hz
F3 (−3 dB, no cabin gain)46 Hz
Example box (outside)14 3/16″ × 14 3/16″ × 12 5/16″
Open sealed box in designer

Ported

deeper, louder
1.13 ft³ (32 L)
Net volume
Tuning (Fb)33 Hz
Portslot 1 15/16 × 14 5/16″, 56 7/8″ long
Port velocity at 3,500 W114 ft/s
F3 (−3 dB, no cabin gain)30 Hz
Example box (outside)31 1/2″ × 15 3/4″ × 11″

At 3,500 W this example’s port will be noisy: air speed 114 ft/s, while the limit is 82 ft/s. It stays quiet up to about 1,800 W. Full power needs a port of at least 39.2 in², which means a bigger box than this example — size it in the designer.

The volume and tuning are the recommendation, but the port doesn’t fit this example box. Size the box and port in the designer.

Open ported box in designer

Deeper: 1.62 ft³ (46 L) tuned to 27 Hz, 21 1/2″ × 15 3/4″ × 16 15/16″ outside — a bigger box with flatter deep bass. Open in the calculator

Where to buy Amazon
203040506080100150200606672788490HzdB
Sealed Ported · SPL in dB at 1 W / 1 m, no cabin gain

Thiele/Small parameters

Size12″
Voice coilsdual 1 Ω
RMS power3,500 W
Fs29.6 Hz
Qts0.47
Qes0.533
Qms4.1
Vas0.94 ft³
Re (one coil)1.19 Ω
Sd70.9 in²
Xmax1.46″
Vd103.3 in³ calc.
Mms322 g calc.
BL11.6 T·m calc.
EBP56 — sealed or ported calc.
Sensitivity, 1 W / 1 m83.1 dB calc.

Mounting dimensions

Ø12 13/16″cutout Ø11 1/8″mounting depth 9 3/4″magnet Ø≈ 7 1/4″
Cutout diameter11 1/8″
Mounting depth9 3/4″
Overall diameter12 13/16″

“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.

Data sources

Other Sky High Car Audio 12″ models

Similar 12″ subwoofers from other brands

Close in Fs, Qts and Vas — a box of similar volume will suit them.

FAQ

What box does the Sky High Car Audio FMX-12 D1 need?

Recommended net volume: 0.92 ft³ sealed, 1.13 ft³ ported tuned to 33 Hz — for one sub in a sedan at 3,500 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.

What are the Sky High Car Audio FMX-12 D1 Thiele/Small specs?

Fs 29.6 Hz, Qts 0.47, Vas 0.94 ft³, Xmax 1.46″, Sd 70.9 in².

What is the Sky High Car Audio FMX-12 D1 mounting depth?

Mounting depth is 9 3/4″, cutout diameter 11 1/8″. The inside depth of the box must exceed the mounting depth by at least 1″.

How much power does the Sky High Car Audio FMX-12 D1 handle and how do I wire it?

RMS power rating: 3,500 W. Dual 1 Ω voice coils: series gives 2 Ω, parallel gives 0.5 Ω at the amp. Wiring for several subs and amp power — in the wiring calculator.