MTX Audio T810-44
10″ subwoofer · dual 4 Ω · 400 W RMS
| Source | web.archive.org · manufacturer data |
|---|---|
| Checked against source | October 2026 |
| Thiele/Small parameters | complete |
| Mounting dimensions | 3 of 4 — missing: magnet diameter; the designer will use an estimate |
Recommended box
For a sedan, one sub, 400 W. It’s the same math as the designer’s step-by-step mode, where you can fit the box to your space, vehicle and amp and get plans, a cut sheet and DXF.
Sealed
smaller, tighter| Bass character (Qtc) | Tight and punchy · 0.80 |
|---|---|
| Fc | 51 Hz |
| F3 (−3 dB, no cabin gain) | 48 Hz |
| Example box (outside) | 12 5/8″ × 12 5/8″ × 15″ |
Ported
deeper, louder| Tuning (Fb) | 42 Hz |
|---|---|
| Port | 2 round ports Ø2 1/2″, 16″ long |
| Port velocity at 400 W | 96 ft/s |
| F3 (−3 dB, no cabin gain) | 37 Hz |
| Example box (outside) | 16 5/16″ × 15 3/4″ × 9 5/8″ |
At 400 W this example’s port will be noisy: air speed 96 ft/s, while the limit is 82 ft/s. It stays quiet up to about 290 W. Full power needs a port of at least 11.7 in², which means a bigger box than this example — size it in the designer.
Open ported box in designerDeeper: 2.08 ft³ (59 L) tuned to 30 Hz, 31 1/2″ × 15 3/4″ × 12 9/16″ outside — a bigger box with flatter deep bass. Open in the calculator
Projects with this subwoofer
Boxes that users designed and published: plans, cut sheet and response graph.
Thiele/Small parameters
| Size | 10″ |
|---|---|
| Voice coils | dual 4 Ω |
| RMS power | 400 W |
| Fs | 39.8 Hz |
| Qts | 0.62 |
| Qes | 0.752 |
| Qms | 3.53 |
| Vas | 0.62 ft³ |
| Re (one coil) | 3.37 Ω |
|---|---|
| Sd | 53.6 in² |
| Xmax | 0.63″ |
| Vd | 33.8 in³ calc. |
| Mms | 155 g calc. |
| BL | 13.2 T·m calc. |
| EBP | 53 — sealed or ported calc. |
| Sensitivity, 1 W / 1 m | 83.7 dB calc. |
Mounting dimensions
| Cutout diameter | 9 1/4″ |
|---|---|
| Mounting depth | 7 1/8″ |
| Overall diameter | 10 3/4″ |
“≈” means the value isn’t in the spec sheet and a typical value for the size is used; “calc.” means it’s calculated from the published parameters. Check the manufacturer’s spec sheet before you build.
Data sources
Other MTX Audio 10″ models
- MTX Audio 3510-04 10″ · 4 Ω
- MTX Audio 3510-04S 10″ · 4 Ω
- MTX Audio 5510-22 10″ · dual 2 Ω
- MTX Audio 5510-44 10″ · dual 4 Ω
- MTX Audio FPR10-04 10″ · 4 Ω
- MTX Audio RT10-04 10″ · 4 Ω
- MTX Audio T4510-04 10″ · 4 Ω
- MTX Audio T5510-04 10″ · 4 Ω
- MTX Audio T9510-44 10″ · dual 4 Ω
- MTX Audio TN10-04 10″ · 4 Ω
- MTX Audio TS8510-22 10″ · dual 2 Ω
Similar 10″ subwoofers from other brands
Close in Fs, Qts and Vas — a box of similar volume will suit them.
- CT Sounds TROPO-10 D4 0.85 ft³ sealed · 1.02 ft³ ported
- Lanzar OPTI1032D 0.99 ft³ sealed · 0.85 ft³ ported
- Memphis Car Audio PRX104 (Power Reference 10" SVC 4ohm) 1.13 ft³ sealed · 1.87 ft³ ported
- Kicker L7 10" 4-Ohm DVC (41L7104) 1.13 ft³ sealed · 1.77 ft³ ported
- American Bass HAWKSLIM-1044 0.78 ft³ sealed · 0.81 ft³ ported
- Sony XS-L10S 0.92 ft³ sealed · 0.92 ft³ ported
FAQ
What box does the MTX Audio T810-44 need?
Recommended net volume: 0.92 ft³ sealed, 0.85 ft³ ported tuned to 42 Hz — for one sub in a sedan at 400 W. Fit the box to your space and amp in the free calculator, with plans and a cut sheet.
What are the MTX Audio T810-44 Thiele/Small specs?
Fs 39.8 Hz, Qts 0.62, Vas 0.62 ft³, Xmax 0.63″, Sd 53.6 in².
What is the MTX Audio T810-44 mounting depth?
Mounting depth is 7 1/8″, cutout diameter 9 1/4″. The inside depth of the box must exceed the mounting depth by at least 1″.
How much power does the MTX Audio T810-44 handle and how do I wire it?
RMS power rating: 400 W. Dual 4 Ω voice coils: series gives 8 Ω, parallel gives 2 Ω at the amp. Wiring for several subs and amp power — in the wiring calculator.